User Manual

Setup is extremely simple:

  1. Install the module in a suitable Eurorack case.
  2. Connect a TOSlink optical cable from the ADAT output of your audio interface to the input of the ES-3.
  3. Turn on.

That really is it. There are no switches, trim pots etc. to set up or configure.

The ES-3 is now acting as an extension of your audio interface. Any signal you want to come out of the ES-3's outputs, simply route in your DAW to the interface's ADAT output channels.

Power

The power connector is Doepfer standard. If using the power cable supplied with the ES-3, the connector is keyed and will only insert into the ES-3 the correct way round, in which case the red edge of the cable is nearest the edge of the PCB, and carries -12V. Be sure to connect the other end of the power cable correctly, again so -12V corresponds to the red stripe on the cable.

The ES-3 can safely be used in a ±15V system with a suitable adaptor cable.

We use cookies and other tracking technologies to improve your experience on this site. We also link to content on external websites which may also gather information about you when you visit them. This is all perfectly normal. You can find out more about cookies (including how to turn them off) here and you can read our Privacy Policy here.